Manufacturer & wholesaler of pure brass · Bulk orders only · Minimum order quantity applies Download catalogue (PDF)

Step 1 of 4 · Made by hand, the Moradabad way

Casting

Every piece begins as molten metal. Brass is melted in the furnace and poured into sand moulds shaped for each design.

Casting – Om Glow, Moradabad
  • 900 °C+heat needed to melt brass
  • Copper + zincthe alloy we cast
  • Sand mouldsMoradabad's traditional method

The story

Where every piece is born

Casting is the oldest part of Moradabad's brass tradition. A pattern of the design is pressed into packed moulding sand, leaving a hollow in exactly the shape of the finished piece — a diya bowl, the stem of a samai, the base of a stand.

The brass — an alloy of copper and zinc — is heated in the furnace until it runs like liquid gold. It is then poured into the mould in one steady stream, so the metal reaches every curve and detail before it begins to set.

Once cool, the mould is broken open and the rough casting comes out of the sand. It looks dull and rough at this stage, but the shape, weight and strength of the final piece are already decided here.

Stage by stage

  1. Making the mould

    The design pattern is pressed into packed moulding sand to form an exact hollow.

  2. Melting the brass

    Copper-zinc brass is heated in the furnace until it is fully liquid.

  3. Pouring

    The molten metal is poured in one go so it fills every detail of the mould.

  4. Cooling & breaking out

    The mould is opened, sand is cleaned off and extra metal is cut away.

Made this way

Pieces that pass through casting

View full catalogue

Catalogue PDF